Home > News > Content
Precautions Before Installing Window Seals
Mar 29, 2018

1, Carefully remove the debris in the tank before installing the glass, such as mortar, bricks, wood, etc., when the glass is placed should be carefully centered to ensure that the gap on both sides is uniform, and more timely positive fix, to prevent collision displacement Deviation from the center of the slot. The


2,Rubber seals can not pull too tight, the length of the material than the assembly length 2O-3Omm. The installation should be in place with a smooth surface, close contact with the glass, glass cuts, and stress around the glass. The rubber band should be cut off at the corner and stick firmly when it is broken.


3. When using sealant caulking to fix the glass, apply a rubber strip or rubber block to squeeze the glass, leaving an injection gap. Injection depth should not be less than 5mm. The glass should avoid vibration before the adhesive cures.


4. The top mounting position is usually located on the window (door) fan, around the frame fan or on the sealing bridge (windscreen) to enhance the seal between the frame and the fan.


5. The top specification is an important factor affecting sliding doors and windows and watertightness. It is also an important factor affecting the opening and closing force of doors and windows. If the top is too big or the pile is too high, not only is assembly difficult, but also the resistance to movement of the doors and windows is increased. In particular, the initial resistance at the time of opening and the final resistance at the time of closing are large.


6, the specification is too small, or the height of the vertical strip is not enough, it is not easy to slot, so that the sealing performance of the doors and windows greatly reduces the picture of the table. The top needs silicidation. The surface appearance of the qualified quality is that the surface is straight, the bottom plate and the vertical hair are smooth, there is no bending, and the bottom plate has no pits, which satisfies the requirement of 0.2 mm.